Drolet GRIZZLY Service Manual download pdf (Page 9)

Page 8 of 23

Chimney installation

• ONLY (‘’A’’ TYPE) FACTORY BUILT CHIMNEY CAN BE USED for the installation of your GRIZZLY

fireplace. Use only 30

or 45

elbows. NO 90

ELBOWS ARE ALLOWED.

• The use of BLACK PIPE CONNECTORS (SINGLE OR DOUBLE WALL PIPES) IS STRICTLY

PROHIBITED.

• Many configurations are possible, the most frequent ones are illustrated in figures 12, 13, and 14.

• Respect clearances indicated in table 1. These clearances have been tested and verified in the

course of certification and homologation sessions. Also respect factory built chimney required

clearances. See your dealer to know the specifications of the chimney manufacturer.

Figure 12 : Direct installation Figure 13 : Inside deviation installation

• NOTE: It is essential to ensure yourself that

the room where the fireplace is located

sufficiently ventilated to provide an adequate

air supply.

• If your home is well insulated, it is possible that

you will have to install an fresh air intake

directly from outside and routed to the unit.

• Drolet Stoves & Fireplaces do not recommend

that you connect a factory built chimney to a

masonry chimney.

Figure 14 : Exterior deviation installation

THE BURNING OF ONE LITRE OF FUEL (OIL) REQUIRES APPROXIMATLY 30 m

OF AIR AND WILL PRODUCE ABOUT 0,8 kg OF WATER VAPOR AND 9 m

CARBONE DIOXIDE AND ATMOSPHERIC NITROGEN. A SOURCE OF AIR FROM

THE OUTSIDE IS NEEDED TO REPLACE COMBUSTION AIR.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

Drolet GRIZZLY Service Manual Page 9