Drolet ESCAPE 45221 User Manual download pdf (Page 15)

An example of the energy values of some common wood fuels is given in Table 3.1

For recommended wood sizes, refer to the specifications.

Common Heating Values of Cordwood

Hardwoods

Million Btu/Cord

Softwoods

Million Btu/Cord

Birch

23.6

Douglas Fir

20.6

White Oak

28.3

Hemlock

17.1

Alder

17.6

Jack Pine

18.4

Table 3.1

3.2.1 Simple Wood Moisture Test

Add one large piece of wood to the top of an established fire. If it starts to burn on three sides within one

minute, it is dry and seasoned and right for burning. If it turns black and starts to burn in three minutes,

it is damp. If it turns black and does not start burning until after five minutes, it is green and wet. If it

hisses at any time, the wood is soaked and will not burn until excess moisture is boiled away.

3.3 Notes About First Firing

Before firing ensure that the room is well ventilated. Curing the paint is recommended to preserve the

best quality finish. Heating the insert too intensely on the first fire will dull and lighten the colour on

overheated areas, and cause smoke and odour to be emitted into the room. To cure the paint, the first

two fires should be burned for only about twenty minutes each.

The paint curing process will produce a light fume with an unpleasant odour. Open windows. Leave the

room if the smell is too intense. The fume is non-toxic and will disappear completely after the unit

will have been used a few times at higher firing temperatures.

Allow the insert to get warm only, but not hot, i.e. 250

F (120

C) as measured by an insert top

thermometer, then allow the insert to cool down. Light a third fire and burn it for about forty minutes to

450

F (230

C) or less. Once again cool the insert to room temperature, then operate it according to the

following instructions. This extra care will result in a more durable, and uniform finish.

3.4 Lighting A Fire

1. Place enough crumpled balls of newspaper or other paper into the insert to cover the

bottom of the firebox.

2. Place small dry kindling on the crumpled paper.

3. Place larger dry kindling on top of the small kindling.

4. Open the draft control fully to the right (located on the right side of the faceplate, Figure 3.1)

5. Light a fire at the bottom of the crumpled paper and close the door. If the fire tends to go out,

momentarily hold the door slightly ajar to fan the fire. As soon as the fire catches hold, close the

door.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comments to this Manuals

No comments

Drolet ESCAPE 45221 User Manual Page 15

Comments to this Manuals

Related products and manuals for Stoves Drolet ESCAPE 45221