Drolet Classic Specifications download pdf (Page 27)

Classic With Blower Installation and Operation Manual

7 Clearances to Combustible Material

The clearances shown in this section have been determined by test according to

procedures set out in safety standards ULC S627 (Canada), UL1482 (U.S.A.) and UL737

(U.S.A.). When the stove is installed so that its surfaces are at or beyond the minimum

clearances specified, combustible surfaces will not overheat under normal and even

abnormal operating conditions.

No part of the stove or flue pipe may be located closer to combustibles than the

minimum clearance figures given.

7.1 Location of the certification label

Since the information given on the certification label affixed to the appliance always

overrides the information published, in any other media (owner’s manual, catalogues,

flyers, magazines and/or web sites) it is important to refer to it in order to have a safe and

compliant installation. In addition, you will find information about your stove (model, serial

number, etc.). You can find the certification label on the back of the stove.

7.2 Clearances to Walls and Ceiling

The clearances to combustible walls may be slightly different in Canada and the U.S.A.

and may also differ depending on whether you use single or double wall flue pipe. Please

be sure to choose the correct clearance for your location and type of flue pipe. See figure

Clearances to combustible materials and floor protection to match each letter to a

clearance.

CLEARANCES

(SINGLE WALL PIPE)

CANADA USA

15" (381 mm) 15" (381 mm)

26" (660 mm) 26" (660 mm)

12" (305 mm) 12" (305 mm)

18¼" (464 mm) 18¼" (464 mm)

35¾" (908 mm) 35¾" (908 mm)

21¼" (540 mm) 21¼" (540 mm)

48" (1220 mm) 48" (1220 mm)

84" (213 cm) 84" (213 cm)