READ AND KEEP THIS MANUAL FOR REFERENCE 45063A Printed in Canada 24-08-2011 OWNER`S MANUAL DROLET NG1800 WOODSTOVES: AUSTRAL, BALTIC, LEGEND AN
10 INSTALLATION SAFETY NOTICE • IF THIS STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOW THE INSTALLATI
11 CLEARANCES TO COMBUSTIBLES AND FLOOR PROTECTOR To install your appliance correctly, it is extremely important to respect all clearances to any comb
12 FIGURE 1.3 Clearances to combustible materials and floor protection
13 FLOOR PROTECTOR If the stove is to be installed on top of a combustible floor, it must be guarded by a non combustible material as shown on figure
14 Following the installation of such a heat radiation shield, the clearances mentioned on the stove certification plate may be reduced as stated in t
15 Graphic 1 A- Minimum clearance required between the appliance and an unshielded combustible ceiling. B- 20 in. (500 mm) minimum; C- 1 in. (
16 Graphic 2 A- 1 in.(25 mm) minimum; 1- Combustible wall; 2- Non-combustible spacers; 3- 0.024’’ (0.61mm) sheet metal. ___________________________
17 Graphic 5 A- 1 in. (25 mm) minimum; 1- Combustible wall; 2- Non-combustible spacers; 3- Brick. __________________________________________________
18 CHIMNEY Your wood stove may be hooked up with a factory built or masonry chimney. If you are using a factory built chimney, it must comply with UL
19 CHIMNEY CONNECTOR Your chimney connector (commonly called stove pipe) and chimney must have the same diameter as the stove’s exhaust outlet. The st
2 TABLE OF CONTENTS INTRODUCTION ...
20 FIGURE 2.3 (B) Minimum Slope • The assembly should be as short and direct as possible between the stove and chimney (See figure 2.4 (A)). The
21 DRAFT Your E.P.A Drolet stove’s performance will be optimised if it is installed with a chimney (flue) system that provides an adequate draft. The
22 TYPICAL INSTALLATIONS FACTORY BUILT CHIMNEY: ROOF FLASHING18" CLEARANCEWALL SUPPORTWALL RADIATION SHIELDRAIN CAP Wall installation CEIL
23 MASONRY CHIMNEY: You can also install your stove using your existing masonry chimney. To do so, follow the guidelines below. You may want to use
24 FACTORY BUILT THIMBLE:
25 BRICK THIMBLE:
26 OUTSIDE COMBUSTION AIR Your DROLET stove is approved to be installed with an outside air intake which is necessary for a mobile home. This type o
27 WOODSTOVE UTILISATION Your heating unit was designed to burn wood only; no other materials should be burnt. Wastes and other flammable materials s
28 TESTING YOUR WOOD When the stove is thoroughly warmed, place one piece of split wood (about five inches in diameter) parallel to the door on the be
29 HEATING Controlled combustion is the most efficient technique for wood heating because it enables you to select the type of combustion you want for
3 INTRODUCTION SBI INC., one of the most important wood stove and fireplace manufacturers in Canada, congratulates you on your purchase and wishes to
30 RELOADING Once you have obtained a good bed of embers, you should reload the unit. In order to do so, open the air controls to maximum a few secon
31 USE OF THE BYPASS DAMPER Your stove is equipped with a bypass damper. This feature should be used, if needed, upon start-up of the stove to help
32 ASH DISPOSAL Ashes should be removed from the stove every few days or when ashes get to 2 to 3 inches deep. Always empty the stove when it is cold
33 MAINTENANCE Your Drolet stove is a high efficiency stove and therefore requires little maintenance. It is important to perform a visual inspection
34 PAINT Only clean your stove with a dry soft cloth that will not harm the paint finish. If the paint becomes scratched or damaged, it is possible to
35 BRICK LAYOUT ITEM PART # DESCRIPTION QTY 1 29015 4 X 9 BRICK 21 2 PL36022 4 X 5 3/8 BRICK 1 3 PL36054 4 X 9 BRICK (CUT) 2 4 SE16059 ASH DUMP CA
36 DROLE LIMITED LIFETIME WARRANTY The warranty of the manufacturer extends only to the original consumer purchaser and is not transferable. This war
4 TECHNICAL SPECIFICATIONS Combustible: Wood Recommended Surface 500 to 2 100 ft2 (46 to 195 m2) Heating Capacity* : E.P.A : Seasoned cordwood: 3
5 *Why is the BTU indicated on the EPA label smaller than the one advertised? You will notice a difference between the BTU output as indicated on the
6 TIPS ON WOOD HEATING Wood is a renewable energy. It is also a very clean heat source when used with appliances that are certified by the U.S. Envir
7 ASSEMBLY BALTIC Pedestal Base Installation: 1. Slide the front part of the pedestal base around the pedestal and fix the rear part with the two s
8 AUSTRAL, LEGEND AND MYRIAD Ash Pan Installation:
9 DOOR ADJUSTMENT In order for your stove to operate properly, the door should be adjusted periodically to provide an air tight fit. To adjust: • R
Comments to this Manuals