Drolet CS1200 Specifications

WOOD STOVE MANUAL STOVE BUILDER INTERNATIONAL. 1700, Léon-Harmel Québec (Qc) Canada G1N 4R9 Tel: 418-527-3060 Fax: 418-527-4311 WWW.DROLET.C

• Roof guys (if required) Stove pipe • An adequate number of stove pipe sections. • A 90o elbow 1- Start by positioning your stove where you wo

4- Then, from outside the building, slide a short chimney length (attached to the tee) through the wall thimble. The chimney must extend at least 3

7- Authorities require that the chimney extend not less than 3 feet above the highest point where it passes through the roof of a building and not le

Stove pipe • Suitable lengths of stove pipe 1- Place your stove where you would like it located and use a plumb line to mark the ceiling directly

4- Once the support is secure, you can begin to assemble the chimney by lowering the first section into the support. Make sure that the male coupler

10- Next, slide the storm collar down the chimney until it contacts the flashing. Tighten the nut and bolt and seal the collar to the chimney wit

16

EXTERIOR AIR INTAKE Since the FX 3000 has been approved for installation in mobile homes, it is equipped with an optional exterior intake. The proced

BAFFLE BRICK INSTALLATION (SAWMAN STOVE ONLY) - The Sawman baffle brick is shipped with the stove. However, in order to avoid shipping damages, it i

OPERATING YOUR DROLET WOOD STOVE FUEL Your stove was designed to burn wood only. No other type of fuel should be used. Waste and other flammable ma

THE DROLET WOOD STOVE MANUAL TABLE OF CONTENTS INTRODUCTION...

Smaller pieces of wood will dry faster. All logs exceeding 6" (152 mm) should be split. The wood should be stored in a place where the grass is

HEATING Once you have obtained a good bed of embers you should reload the unit. In order to do so, open the air control completely for a few seconds

MAINTENANCE OF THE HEATING SYSTEM MAINTENANCE OF THE STOVE Our wood stoves are designed so that they will require little maintenance: - It is wise

MAINTENANCE OF THE CHIMNEY Whether you have a prefab or masonry chimney, you must conduct a visual inspection at least once a month in order to be su

FREQUENTLY ASKED QUESTIONS WHAT DO THE WORDS “DRAFT” AND “NEGATIVE PRESSURE” MEAN? The word “draft” refers to the hot air movement that circulat

DRAWING #1 DRAWING #1 shows a stove functioning under normal and adequate conditions. Heat rises to the upper floors and the room where the stove is

DRAWING #2 DRAWING #2 shows the effect of a cold chimney. Cold air creates a reverse draft (negative pressure), which causes smoking problems. Thi

DRAWING #3 DRAWING #3 shows the effect of negative pressure caused by an air-moving device inside the house. In the example above, the range ho

DRAWING #4 DRAWING #4 shows the negative pressure effect caused by wind, influenced by nearby structures such as a building. 28

DRAWING #5 DRAWING #5 shows the negative pressure effect that can be caused by wind, influenced by nearby structures such as a tree. 29

INTRODUCTION THE DROLET WOOD STOVE MANUAL SBI INC., one of the most important wood stove and fireplace manufacturers in North America, congratulate

CAN I MODIFY MY STOVE TO INSTALL A GLASS DOOR? It is forbidden to modify a stove. Stoves are safety tested with a specific configuration, drawings

1700, rue Léon-Harmel, Québec (Québec) G1N 4R9 tel. : (418) 527-3060 fax : (418) 527-4311 e-mail : [email protected] web site : www.drolet.ca LIM

ASSEMBLING THE STOVE Note: This section applies to models Compak, CS1200, ML, Little Sawman, RC and Nordic only. 1- Mount the 4 legs using 2 screw

INSTALLING THE FIREBRICKS Note: This section applies to models Compak, CS1200, ML, Little Sawman , RC and Nordic only. 5

INSTALLATION OF YOUR DROLET WOOD STOVE POSITIONING THE STOVE It is very important to position the wood stove as close as possible to the chimney, an

CLEARANCES TO COMBUSTIBLE MATERIALS It is of utmost importance that the clearances to combustible material mentioned on your wood stove certification

INSTALLATION OF A HEAT RADIATION SHIELD Following the installation of a heat radiation shield, the clearances mentioned on the stove certification pl

CHIMNEY Your wood stove may be hooked up with a prefabricated or masonry chimney. If you are using a prefab chimney, it must comply with S-629 stand